Neon rubber base.
– This is a new generation rubber base with a color that can be varnished like a gel varnish or modeled by smoothing the nail plate.
– The base has elasticity, good cushioning, firmness and excellent pigmentation.
- Thick consistency.
– Nails coated with this base have excellent adhesion to the natural nail plate.
- Perfectly evens out by itself, fills all the unevenness of the nail, does not run into the cuticles.
Thanks to its elasticity, it strengthens the nail plate and protects it from breakage.
Workflow:
1. We will remove the old material (if any) with a carbide tip with red tape (recommended only for craftsmen with practice) or dissolve with the help of cosmetic acetone. We smooth the surface of the material with a file 180/240 gr., wet a sheet of cotton wool or cellulose with acetone, we put it only on the surface of the material so that the liquid does not come into contact with the skin, cover with foil and keep for about 10 minutes. until the material thaws. We push the material with a peeler or orange stick.
2. A file of 180/240gr is used to prepare the nail.
3. We push back the cuticles and perform a hardware or combined manicure.
4. Clean the dust from the surface of the nail well.
5. Apply a dehydrator on the nail, let the substance evaporate.
6. We cover the surface of the nail with super bond.
7. Cover the nails with a thin layer of "rubber" base, rub a small amount of the material into the nail the surface of the nail plate and polymerized in an LED lamp for 60 seconds.
8. We put a small amount of material on the surface of the nail, using light movements without pressing brush to the surface of the material, we shape it by stretching it towards the free edge of the nail and let it go for the material to self-distribute and equalize. How much material to add depends natural nail plate type. We form the material on one surface of the nail, briefly capturing the material in the lamp. After covering all the nails, we definitely polymerize them in the LED lamp for 60 sec.
9. If the material is unevenly distributed in some place, we can a little bit of it lengthened, shaped with a file 180/240 gr. after cleaning the dispersion with "cleanser" and cellulose sheet.
10. We push the skins aside to make sure that there is no "rubber" base that has escaped anywhere on the skins.
11. We cover with the top layer - "Bright crystal no wipe", polymerize in an LED lamp for 120 seconds. 12. We apply oil on the surface of the cuticles.